Customer Support
(254) 654-0522


Manufacturer: Secon
Availability: Usually ships in 1-2 weeks
The underwater pinpoint metal detector SECON UWPP 10 is particularly suited for the detection and determination of the position of metal objects buried within the diver´s reach. Due to the pinpoint detection objects can be recovered without stirring up the sediment. This makes the recovery of detected objects easy. 

Price $362.00

Shipping cost from $42.00
Calculate shipping cost

Add to Cart

SECON Underwater pinpointer UWPP 10 metal detector  

  • Pinpoint location
  • Detects very small metal objects
  • Easy to operate
  • Lightweight, rugged design

General Overview

Essential technical features of the detector are based on the well proven Ebinger technology which is applied in metal detectors used in humanitarian mine action worldwide. The underwater pinpoint metal detector enhances the SECON range of underwater metal detectors by an inexpensive and easy to use device. It detects all types of metals. The detection range depends on the size, distance and type of metal object to be detected. Objects of small and medium size can be easily recovered by the diver. The underwater pinpoint metal detector is particularly suited for the detection and determination of the position of metal objects buried within the diver´s reach. Due to the pinpoint detection objects can be recovered without stirring up the sediment. This makes the recovery of detected objects easy. Due to the slim cylindrical sensor the detection focus at the tip of the probe is concentrated to a few square centimetres allowing a pinpointing location of target objects despite the detector´s high sensitivity.

Mode of operation

The UW-Pinpointer operates by a micro-controller based pulse induction principle (PI), transmitting short magnetic pulses into the seabed. The primary transmission pulses cause eddy currents in the objects generating response signals which are picked up by the detector and analysed digitally. A vibration of the detector handle indicates the detection of an object obviating the need for a cable connected earphone necessary for any audio signals. Due to the static search mode the detected objects show a footprint spreading over the seabed which helps to estimate the approximate size of the hidden object.

Constructional feature

All detector components are contained in a tube of approx. 23 cm length. The device is switched on and off by a rotation of the battery compartment´s closure. The detector is powered by a 9 V PP3 battery (IEC 6 LR61), or its rechargeable version. The sensor is built into the slim cylindrical end of the tube, which assists in pinpointing even small objects in areas of constricted space like trenches or holes.

  • Power supply: 1 x 9 Volt E-block battery (6LR61) or 1 x 9 Volt E-block rechargeable battery (6F22)
  • Operating time: *1 battery approx. 6.5 h rechargeable battery approx. 3.0 h Corresponds to approx. 6/3 dives
  • Temperature range approx.: - 10 °C to + 55 °C
  • Dimensions:
    • length overall approx. 230 mm
    • handle length approx. 150 mm
    • handle approx. 35 mm Ø
  • Weight approx.: 270 g including battery
  • Pressure test: approx. 7 bar (60 m)

* Depends on the temperature and the quality of the battery / rechargeable battery used.

  • UWPP 10 Pinpointer
  • Lanyard
  • Operating instructions
SECON provides a limited warranty to the original purchaser against all defects in original workmanship and material under normal SCUBA use and service as outlined in the owner's manual for 1 year from the date of purchase, with the following exceptions and conditions:
  • This warranty does not cover rental use.
  • Should your equipment prove to be defective for any reason (other than those listed in the limitations section below) it will be repaired or replaced at SECON´s discretion, free of charge, excluding shipping and handling charges.
  • Repairs made under this warranty will not extend the warranty period
  • This warranty is non-transferable and applies to the original purchaser only.
  • All correspondence concerning this warranty must be accompanied by a copy of the original sales receipt.
  • Any flood or damage, for any reason, that is caused from flooding an O-ring sealed or water tight area will not be covered under warranty. All O-ring sealed products undergo extensive factory pressure testing before being shipped and delivered and are therefore guaranteed to be sealed and functioning when shipped from the factory.
  • SECON will not be liable for any loss, damages, or expenses including incidental or consequential damages directly or indirectly arising from the sale or use of the product.
  • All paint finishing, cosmetic discoloration of surfaces, powder coating, or material stitching that is chipped, damaged, or unthreaded through customer use is not covered in the warranty.
  • SECON does not warranty any product for aesthetic finishes. Issues with surface finish that do not affect function of the product are not covered under warranty.
  • This warranty does not apply and may be rendered completely void in the event of accidental damage, abuse, overcharging of battery, flooding due to neglect, tampering, lack of care and maintenance, improper storage, or unauthorized service.
  • This warranty specifically excludes cords, connectors, O-rings, fuses or other conditions resulting from misuse and negligence.
  • This warranty becomes void if the product components are damaged by anything other than normal recreational diving use.
  • Modifications or repair by anyone other than an authorized SECON Dealer or ADITECH Service Department will void the warranty.
  • Each product is carefully examined and checked before it is shipped. It should therefore be visually and operationally checked as soon as it is received. If it is damaged in anyway, a claim should be filed with the courier and ADITECH notified of the damage.
  • By purchasing this product you agree and understand that in no event will SECON, its distributors or retailers, be held liable for any personal injuries resulting from its operation, or any other damage whether direct, indirect, incidental or consequential, even if SECON or ADITECH is advised of such damages.

NOTE: If the equipment is not covered by warranty, or if it is determined that the fault is caused by misuse, repair will be billed to the customer, and an estimate submitted for customer approval before the commencement of repairs